LOCATION OF CAM SHAFT POSITION SENSOR
Please can anyone tell me where the cam shaft position sensors are located on a 2004 Nissan Quest and how to replace them.
Thanks
Nissan Quest Forum Community
On a Quest for the Ultimate Van
Nissan Quest Forum CommunityOn a Quest for the Ultimate Van |
|
NavigationUser loginRecent comments
|
LOCATION OF CAM SHAFT POSITION SENSORPlease can anyone tell me where the cam shaft position sensors are located on a 2004 Nissan Quest and how to replace them. Thanks |
New forum topicsSyndicate Who's new
Who's onlineThere are currently 0 users and 5 guests online.
|
Dead mouse in main ventilator on circular console
Can anyone tell me how to get the main ventilator located at the top of the circular console out to retrieve the dead mouse? I just paid $82 to clean out the blower housing in the engine which was full of dried blown insulation from the mouse making a nest. The mechanic could not find it in the blower housing and from the smell I suspect it is in the ventilator shaft. Anyone?
Console
The console is held in by four pressure clips. They are located on each side (east and west) of the circle (mid-point), where the pilar is in two pieces. The other two are located at the bottom of the circle, both approxamately 3.5 inches from midpoint of bottom. Carefully pry the top off at those locations, slow and easy. You will also need to remove the Shifter knob. Slide the sleeve down under the knob to access the disconnect, once disconnected the knob will slide right off.
Be careful while taking off that cover, they are about $180 from Nissan.
Let us know how it went.
"No eating in the car"