Home » Forums » General Discussion » 2004 - 2009 Nissan Quest

replaced front wheel bearings and traction,brake and abs light on now

ryan77's picture
Submitted by ryan77 on Sun, 2010-02-07 21:05

i replaced wheel bearings, pads rotors on my 2004 nissan quest now the traction, abs and brake light are on. I tried disconecting the battery to reset but its still there. is there a procedure to reset them.

‹ vin number Air Conditioning Problems ›
»
kolargun's picture

ABS Sensor

Submitted by kolargun on Mon, 2010-08-30 22:13.

You broke off the ABS sensor. I did the same today, now I trying to figure out how to replace it. The part that I broke off and didn't know till I was cleaning up is about 3/8" squire by 1/4" thick.

»
yabufire's picture

I had to replace my hub

Submitted by yabufire on Mon, 2010-08-16 16:23.

I had to replace my hub bearing wheel assemblies as well. The shop that did it accidentally severed the ABS wires attached to the rear assemblies. They fixed it for free.

—

Yabufire
Sparks, NV

»
rslsuwanee's picture

Wheel hub replacement

Submitted by rslsuwanee on Fri, 2010-08-27 08:15.

How much time in labor to replace one side?

Thanks

»
rtquest's picture

this may sound like a silly

Submitted by rtquest on Wed, 2010-02-17 16:05.

this may sound like a silly question but did you remove the sensors before you pulled the hubs...they will be destroyed by the hub on the way out if not....mine would not come out in one piece as the body is rubber and seizes in the hole, another shitty nissan design....they are 300 a piece to replace

»
delimex007's picture

Mostly a sensor problem

Submitted by delimex007 on Thu, 2010-02-11 22:41.

I have the 04 Quest and I had the CEL,Slip light and the VSC off light once.. Went to the dealer -It was a camshaft sensor..Part was $90..Labor was $200. But the lights have absolutely no relation to the wheel bearings,rotors,pads..This is an electrical sensor problem.Hope this helps..Keep us posted on the follow up.

»